Calibre How to Extract Parasitic Inductance using Calibre xL

2024-05-29T21:23:37.000-0400
Parasitic Extraction (PEX)

Summary

Details

image.png
 
With frequency ranges for 5G communication exceeding 40Ghz, designers must ensure that their designs take into account post-layout resistance, capacitance, and inductance parasitics to confirm design simulation results match the silicon-fabricated results.
 
Calibre® xL is fully integrated with xRC, xACT & xACT3D to get a single RCCLM netlist in a single PEX run. It supports two use models:
a) Block Level RCCLM model
b) Block Level RCC model with critical net selection with RCCLM model
 

This Support Kit should help you:

  • Understand the different use models and modes (PEEC/LOOP) that are supported in Calibre xL
  • Use LOOP mode to extract Block level RCCLM
  • Use PEEC mode to extract Block level RCC, and select critical nets RCCLM 
  • Extract a single RCCLM netlist in the same PEX run

Estimated time to complete: 30 minutes

Version Information: 2024.2

==================================================

Both Instructions and Demo Data are attached to this article

Instructions: How to Extract Parasitic Inductance using Calibre xL_000132689.pdf
Data: 000132689.tar.gz
 

Unpublished work. (c) 2022 Siemens

This software or file (the “Material”) contains trade secrets or otherwise confidential information owned by Siemens Industry Software Inc. or its affiliates (collectively, “SISW”), or SISW’s licensors. Access to and use of this information is strictly limited as set forth in one or more applicable agreement(s) with SISW. This Material may not be copied, distributed, or otherwise disclosed without the express written permission of SISW, and may not be used in any way not expressly authorized by SISW.

Unless otherwise agreed in writing, SISW has no obligation to support or otherwise maintain this Material. No  representation or other affirmation of fact herein shall be deemed to be a warranty or  give rise to any liability of SISW whatsoever.

SISW reserves the right to make changes in specifications and  other information contained herein without prior notice, and the reader should, in all cases, consult SISW to determine whether any changes have been made.

SISW MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS MATERIAL INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF  MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, AND NON-INFRINGEMENT OF INTELLECTUAL PROPERTY. SISW SHALL NOT BE LIABLE FOR ANY DIRECT, INDIRECT,INCIDENTAL, CONSEQUENTIAL OR PUNITIVE DAMAGES, LOST DATA OR PROFITS, EVEN IF  SUCH DAMAGES WERE FORESEEABLE, ARISING OUT OF OR RELATED TO THIS PUBLICATION OR THE INFORMATION CONTAINED IN IT, EVEN IF SISW HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

TRADEMARKS: The trademarks, logos, and service marks (collectively, “Marks”) used herein are the property of Siemens AG, SISW, or their affiliates (collectively, “Siemens”) or other parties. No one is permitted to use these Marks without the prior written consent of Siemens or the owner of the Marks, as applicable. The use herein of third party Marks is not an attempt to indicate Siemens as a source of a product, but is  intended to indicate a product from, or associated with, a particular third party. A list of Siemens’ Marks may be viewed at: www.plm.automation.siemens.com/global/en/legal/trademarks.html

Support Center: support.sw.siemens.com
Send Feedback on Documentation: support.sw.siemens.com/doc_feedback_form

==================================================

 

KB Article ID# KB000132689_EN_US

Contents

SummaryDetails

Associated Components

Calibre Parasitic Extraction Calibre xACT 3D Calibre xL Calibre xACT Calibre xRC